laboratory evaluations of the formation potential of regulated gases and unregulated polycyclic aromatic hydrocarbon (PAH) emissions for a Mammoth passive diesel particulate filter (DPF) (NRCan-5000063050)

2021-11-03 00:00:00

None

2021/11/18 14:00 Eastern Daylight Time (EDT)

National Capital Region

Natural Resources Canada

Natural Resources Canada

World

Limited

PW-21-00973533

NRCan-5000063050

Advance Contract Award Notice (ACAN) An ACAN is a public notice indicating to the supplier community that a department or agency intends to award a contract for goods, services or construction to a pre-identified supplier, thereby allowing other suppliers to signal their interest in bidding, by submitting a statement of capabilities. If no supplier submits a statement of capabilities that meets the requirements set out in the ACAN, on or before the closing date stated in the ACAN, the contracting officer may then proceed with the award to the pre-identified supplier. Definition of the requirement The Department of Natural Resources Canada (NRCan) has a requirement to Vale and Mammoth Equipment & Exhausts (Mammoth), in cooperation with Natural Resources Canada (NRCan), will conduct a laboratory evaluations of the formation potential of regulated gases and unregulated polycyclic aromatic hydrocarbon (PAH) emissions for a Mammoth passive diesel particulate filter (DPF). Please see Appendix A for compounds of interest. The DPF is intended for use by Vale on large mining equipment CanmetMINING will employ a 242 kW Detroit Diesel Series 60 reference engine for all emissions studies. This engine is calibrated and its performance, fuel economy and emissions are well known, tested and documented. Any small changes in emissions or performance caused by fuel properties can be detected and measured to a high statistical accuracy. The scope of the project does include measurement of non-regulated emissions or toxics by external contractor. CanmetMINIING proposes both an engine out, baseline, and DPF out, assessment of regulated and nom-regulated emissions using mining fuel. The test regime will compose of ISO 8178 C1 test cycle of extended duration per mode point. The following test data will be recorded for all tests; speed, power, torque, fuel consumption and regulated emissions including; CO, CO2, NO, NO2, O2, THC and diesel particulate matter (tailpipe). In addition special samples will be collect to assess PAHs and/or nPAHS . This analysis will be carried out by an external contractors. The CanmetMINING laboratory standard engine will be installed in the test cell and a baseline emission test will be performed using CSA certification fuel. The baseline test will consist of one the ISO8178 C1 cycle. CanmetMINING will repeat in duplicate this process for tailpipe, DPF out. For the purposes of costing, this scope includes one baseline test and two duplicate tests. Canmet MINING will prepare a draft report for the CLIENT’s review to include reference to external contractors report summarizing the PAH results of the sampling program. CanmetMINING will reference in the final report from literature, comparison of non-regulated from similar type engines Criteria for assessment of the Statement of Capabilities (Minimum Essential Requirements) Any interested supplier must demonstrate by way of a statement of capabilities that its exhaust gas sampling system meets all of the following requirements: Capable of sampling for all the following compounds of interest: Volatile Organic Compounds Benzene Formaldehyde Acetaldehyde 1,3-Butadiene Dioxins and Furans (total as TEQ) 2,3,7,8 Tetrachlorodibenzo-p-dioxin (2,3,7,8 T4CDD) 1,2,3,7,8 Pentachlorodibenzo-p-dioxin (1,2,3,7,8 P5CDD) 1,2,3,4,7,8 Hexachlorodibenzo-p-dioxin (1,2,3,4,7,8 H6CDD) 1,2,3,6,7,8 Hexachlorodibenzo-p-dioxin (1,2,3,6,7,8 H6CDD) 1,2,3,7,8,9 Hexachlorodibenzo-p-dioxin (1,2,3,7,8,9 H6CDD) 1,2,3,4,6,7,8 Heptachlorodibenzo-p-dioxin (1,2,3,4,6,7,8 H7CDD) Octachlorinated dibenzo-p-dioxin (O8CDD) 2,3,7,8 Tetrachlorodibenzofuran (2,3,7,8 T4CDF) 1,2,3,7,8 Pentachlorodibenzofuran (1,2,3,7,8 P5CDF) 2,3,4,7,8 Pentachlorodibenzofuran (2,3,4,7,8 P5CDF) 1,2,3,4,7,8 Hexachlorodibenzofuran (1,2,3,4,7,8 H6CDF) 1,2,3,6,7,8 Hexachlorodibenzofuran (1,2,3,6,7,8 H6CDF) 1,2,3,7,8,9 Hexachlorodibenzofuran (1,2,3,7,8,9 H6CDF) 2,3,4,6,7,8 Hexachlorodibenzofuran (2,3,4,6,7,8 H6CDF) 1,2,3,4,6,7,8 Heptachlorodibenzofuran (1,2,3,4,6,7,8 H7CDF) 1,2,3,4,7,8,9 Heptachlorodibenzofuran (1,2,3,4,7,8,9 H7CDF) Octachlorinated dibenzofuran (O8CDF) Polynuclear Aromatic Hydrocarbons (PAHs) Naphthalene 1-Methyl naphthalene 2-Methyl naphthalene Acenaphthene Acenaphthylene Phenanthrene Nitrated Polynuclear Aromatic Hydrocarbons (nPAHs) Pyrene 1-nitro-naphthalene Fluoranthene 2-nitro-naphthalene Chrysene 3-nitro-phenanthrene Benz(a)-anthracene 9-nitro-phenanthrene Benzo(b)-fluoranthene 9-nitro-anthracene Benzo(k)-fluoranthene 3-nitro-fluoranthene Benzo(a)-pyrene 1-nitropyrene Indene(1,2,3- cd) pyrene 1-nitro-naphthalene Capable of performing the sample collection and analysis according to the following methods: • United States Environmental Protection Agency (US EPA) Compendium Method TO-15: Determination Of Volatile Organic Compounds (VOCs) In Air Collected In Specially- Prepared Canisters And Analyzed By Gas Chromatography/ Mass Spectrometry (GC/MS); • US EPA Compendium Method TO-11A: Determination of Formaldehyde in Ambient Air Using Adsorbent Cartridge Followed by High Performance Liquid Chromatography (HPLC) [Active Sampling Methodology] OR California Air Resources Board (CARB) Method 430: Determination of Formaldehyde and Acetaldehyde in Emissions from Stationary Sources); • Environment Canada EPS 1/RM/2: Measurement of Releases of Semi-Volatile Organic Compounds from Stationary Sources, and EPS 1/RM/3: A Method for the Analysis of Polychlorinated Dibenzo-para-dioxins (PCDDs), Polychlorinated Dibenzofurans (PCDFs) and Polychlorinated Biphenyls (PCBs) in Samples from the Incineration of PCB Waste OR US EPA Method 23: Determination of Polychlorinated Dibenzo-p-Dioxins and Polychlorinated Dibenzofurans From Stationary Sources. Having prior experience in storage and transport of sensitive compounds. Applicability of the trade agreement(s) to the procurement This procurement is subject to the following trade agreement(s) Canadian Free Trade Agreement (CFTA) Comprehensive and Progressive Agreement for Trans-Pacific Partnership (CPTPP) Canada-Chile Free Trade Agreement (CCFTA) Canada-Colombia Free Trade Agreement Canada-Honduras Free Trade Agreement Canada-Korea Free Trade Agreement Canada-Panama Free Trade Agreement Canada-Peru Free Trade Agreement (CPFTA) Canada-Ukraine Free Trade Agreement (CUFTA) Justification for the Pre-Identified Supplier The supplier mentioned in section 13 below is the only known supplier that meets the mandatory criteria set out in section 3 above. Should Canada receive a statement of capabilities from a supplier that contains sufficient information to indicate that it meets the requirements set forth in this ACAN, a competitive process will be triggered with a technical and financial evaluation methodology of the bids proposed by the potential bidders Government Contracts Regulations Exception(s) The following exception(s) to the Government Contracts Regulations is (are) invoked for this procurement under subsection 6(d) - "only one person is capable of performing the work". The identified supplier, Montrose Environmental, is the only one able to meet all of the criteria identified in paragraph 3 above Exclusions and/or Limited Tendering Reasons The following exclusion(s) and/or limited tendering reasons are invoked under the: Canadian Free Trade Agreement (CFTA) – Article: 513.1(b) (iii); Comprehensive and Progressive Agreement for Trans-Pacific Partnership (CPTPP) – Article(s): 15.10 , 2 (b) (iii) (s) Canada-Chile Free Trade Agreement (CCFTA) – Article(s) Kbis-09 (b),Article Kbis-09 (c) Canada-Colombia Free Trade Agreement – Article(s): 1409 (b) (iii); Canada-Honduras Free Trade Agreement – Article(s): 17.11 2 (b) (iii) Canada-Korea Free Trade Agreement – Article 14.3, Under the Revised GPA - Article XIII, 1 (b) (iii); Canada-Panama Free Trade Agreement – Article(s) 16.10 (b) (iii) Canada-Peru Free Trade Agreement (CPFTA) – Article(s1409 (b) (iii) Canada-Ukraine Free Trade Agreement (CUFTA) – Article(s Article 10.13 (b) (iii); Period of the proposed contract or delivery date The proposed contract is for a period of 1 years from date of contract award until March 31, 2022. Cost estimate of the proposed contract The estimated value of the contract, including option(s), is 159,000 x (GST/HST extra) Name and address of the pre-identified supplier Montrose Environmental Group 704 Mara Street, Suite 210 Point Edward ON N7V 1X4 Suppliers' right to submit a statement of capabilities Suppliers who consider themselves fully qualified and available to provide the goods, services or construction services described in the ACAN may submit a statement of capabilities in writing to the contact person identified in this notice on or before the closing date of this notice. The statement of capabilities must clearly demonstrate how the supplier meets the advertised requirements. Closing date for a submission of a statement of capabilities November 18th, 2021 at 2PM EST will be the closing date for submissions against the statement of capabilities. Inquiries and submission of statements of capabilities Inquiries and statements of capabilities are to be directed to: Daniel Burley Procurement Specialist Natural Resources Canada daniel.burley@nrcan-rncan.gc.ca 343-543-7809

Burley, Daniel

Daniel.Burley@canada.ca

343-543-7809

580 Booth Street Ottawa ON K1A 0E4 CA