Notice of Intent to Sole Source - Steel Plate ASTM A709 HPS 100W – 4” x 80” x 96”.

Notice ID:

Notice of Intent to Sole Source - Steel Plate ASTM A709 HPS 100W – 4” x 80” x 96”.

Department/Ind. Agency:

DEPT OF DEFENSE

Sub-tier:

DEPT OF DEFENSE

Sub Command:

W07V ENDIST ST PAUL

Office:

W07V ENDIST ST PAUL

All Dates/Times are:

(utc-06:00) central standard time, chicago, usa

Updated Published Date:

(utc-06:00) central standard time, chicago, usa

Original Published Date:

0000-00-00 00:00:00

Original Response Date:

dec 27, 2021 11:00 am cst

Inactive Policy:

15 days after response date

Initiative:

• None***--***

Original Set Aside:

total small business set-aside (far 19.5)

Product Service Code:

9640 - iron and steel primary and semifinished products

NAICS Code:

331110 - iron and steel mills and ferroalloy manufacturing

Original Set Aside:

The U.S. Army Corps of Engineers - St. Paul District intends to award a sole source contract modification to R & G Steel, Inc. for the purchase of the following items: 3 EA Plate Steel, ASTM A709 HPS 100W 4" x 80" x 96" a) Dimensions of master plate is 4” thick x 8’ x 20’ and then cut into three equal sections of 4” x 6’ 8” x 8’ (plus/minus ½”). b) A 4” x 4” sample of steel to be cut from any of the four corners of each piece is acceptable to conduct testing. c) Per ASTM A709 Paragraph 4.1 and 4.2, “W” denotes the requirement for impact testing of the material, where “W” denotes that the material will be used for fracture critical, tension components. d) HPS denotes High Performance Steel e) Minimum tensile strength of 110-130 ksi (760-895 MPa) f) Charpy V-Notch impact toughness minimum of 35 ft lbs @ -30 F (48J @ -34C) (all zones) g) Thru-thickness Property (Z-quality plate) shall be addressed to avoid the lamination tearing issues in the Mill Certificate. h) Must conform to Buy American Act. i) Final product shall be clean and free of any oil or grease, dross, slag or burrs. All cut edges (regardless of method) shall have a surface roughness acceptable for welding. j) Final product shall be legibly marked with the applicable designation, grade, heat number, size and thickness, name brand, or trademark of the manufacturer for identification and shipment. k) Bundle and band the steel material as required for shipping, with cribbing at minimum six inches above the base of the shipping platform to allow offloading with a forklift and/or crane. Covering of the material during shipment is not required. Delivery of steel FOB(Destination) Pleasant Valley, IA shall be no later than 1 April 2022. Any vendor who believes they can meet or exceed the requirements shall contact John Riederer, Contract Specialist, with proposed pricing.

KO CONTRACTING DIVISION 180 FIFTH STREET EAST SUITE 700

SAINT PAUL , MN 55101-1678

USA

Primary Point of Contacts:

John P Riederer